More than a few people would love to have more counter space in their kitchen. A great way to get this without engaging in an expensive and messy renovation is to create a stop top cover. Not only will these covers provide a few additional feet of counter space, but they can also help keep dust, crumbs, and crud off the stove. It also offers a nice cutting-board-like surface.
When the project is done, it is possible to personalize or customize the stove cover using a laser cutting machine, such as https://www.facebook.com/BossLasers/. For those who are interested in creating this cover, keep reading. Some helpful tips to do this can be found below.
Important Tip: Remember, when a stove cover is made from wood, this is a material that can catch fire. It is never a good idea to put the lid on a stove that is still warm. It should only be used on stovetops that are cool while they are turned off.
Measure the Stove
The first step is to measure the stove. Most stoves are a standard width, but they may vary in depth. This is especially true of the controls are in the back. Be sure to make the interior dimensions of the cover large enough to cover the stove.
Cut the Necessary Pieces for the Stove Cover
With a miter saw, cut seven (or more) pieces of wood based on the stove's depth. Remember, it is always possible to trim them down if necessary. To do this, use tongue and groove or standard one by fours. The total number needed to depend on the stovetop cover opening.
It is possible to use any wood for this process. However, if someone wants to use the surface for food prep, they need to finish the wood in something that is food safe. Also, it will be best if hardwood is chosen, such as walnut or maple.
Glue the T&G Boards to Each Other
Apply quality wood glue to the grooves of the boards. Once in place, clamp the panels together. Give the glue plenty of time to dry thoroughly.
Trim the Wood and Add Sides
After the glue is fully dry, remove the clamps and use a circular saw or table saw for trimming down the sides. Be sure to cut all sides, so they are smooth. No tongue and grooves should be showing.
Cut one by four tongue and groove boards to trim the edges of the piece. Miter the corners at 45 degrees to create a more seamless look. These pieces need to be cut to fit around the edges to provide clean joints and a tight fit. Once they are cut to size, trim the tongues using a table saw.
Customize the Piece
Once these steps are complete, it is possible to customize the surface with a laser cutter or a stencil. This is a great way to ensure the new décor matches well with the rest of the kitchen.
When it comes to creating a stove cover, using the steps above will help ensure the process is successful. Being informed and knowing what to do is the best way to ensure that quality results are achieved.